352 VLAN Commands
no vlan This command deletes an existing VLAN. The ID is a valid VLAN identification
number (ID 1 is reserved for the default VLAN). The VLAN range is 2-4093.
vlan acceptframe This command sets the frame acceptance mode on an interface or range of
interfaces. For VLAN Only mode, untagged frames or priority frames received
on this interface are discarded. For Admit All mode, untagged frames or priority
frames received on this interface are accepted and assigned the value of the
interface VLAN ID for this port. For admituntaggedonly mode, only untagged
frames are accepted on this interface; tagged frames are discarded. With any
option, VLAN tagged frames are forwarded in accordance with the IEEE 802.1Q
VLAN Specification.
no vlan
acceptframe
This command resets the frame acceptance mode for the interface or range of
interfaces to the default value.
vlan ingressfilter This command enables ingress filtering on an interface or range of interfaces. If
ingress filtering is disabled, frames received with VLAN IDs that do not match
the VLAN membership of the receiving interface are admitted and forwarded to
ports that are members of that VLAN.
Format
no vlan
2-4093
Mode VLAN Config
Default all
Format
vlan acceptframe {admituntaggedonly | vlanonly | all}
Mode Interface Config
Format
no vlan acceptframe
Mode Interface Config
Default disabled
Format
vlan ingressfilter
Mode Interface Config
To Next Page
Loading...
