NetApp CN1610 - GVRP Commands; Set Gvrp Adminmode; No Set Gvrp Adminmode; Set Gvrp Interfacemode

394 GVRP Commands
GVRP Commands
This section describes the commands you use to configure and view GARP
VLAN Registration Protocol (GVRP) information. GVRP-enabled switches
exchange VLAN configuration information, which allows GVRP to provide
dynamic VLAN creation on trunk ports and automatic VLAN pruning.
Note
If GVRP is disabled, the system does not forward GVRP messages.
set gvrp
adminmode
This command enables GVRP on the system.
no set gvrp
adminmode
This command disables GVRP.
set gvrp
interfacemode
This command enables GVRP on a single port (Interface Config mode), a range
of ports (Interface Range mode), or all ports (Global Config mode).
Default disabled
Format
set gvrp adminmode
Mode Privileged EXEC
Format
no set gvrp adminmode
Mode Privileged EXEC
Default disabled
Format
set gvrp interfacemode
Mode ◆ Interface Config
◆ Interface Range
◆ Global Config