NetApp CN1610 - No Accounting; Show Accounting

86 User Account Commands
The following is a example of the command.
(CN1610) #
(CN1610) #configure
(CN1610) (Config)#line telnet
(CN1610)(Config-line)# accounting exec default
(CN1610) #exit
no accounting Use this command to remove accounting from a Line Configuration mode.
show accounting Use this command to display ordered methods for accounting lists.
The following shows example CLI display output for the command.
(CN1610) #show accounting
Format
accounting {exec | commands } {default | listname}
Mode Line Configuration
Parameter Description
exec Causes accounting for an EXEC session.
commands This causes accounting for each command execution
attempt. If a user is enabling accounting for exec
mode for the current line-configuration type, the
user will be logged out.
default The default Accounting List
listname Enter a string of not more than 15 characters.
Format
no accounting {exec|commands]
Mode Line Configuration
Format
show accounting
Mode Privileged EXEC