Chapter 7: Quality of Service Commands 689
The first occurrence of the
time
argument is the starting hours:minutes which the
configuration that referenced the time range starts going into effect. The second
occurrence is the ending hours:minutes at which the configuration that referenced
the time range is no longer in effect.
The hours:minutes are expressed in a 24-hour clock. For example, 8:00 is 8:00
am and 20:00 is 8:00 pm.
no periodic This command deletes a periodic time entry from a time range
show time-range Use this command to display a time range and all the absolute/periodic time
entries that are defined for the time range. Use the
name parameter to identify a
specific time range to display. When
name is not specified, all the time ranges
defined in the system are displayed.
The information in the following table displays when no time range name is
specified.
Format
periodic
days-of-the-week
time
to
time
Mode Time-Range Config
Format
no periodic
days-of-the-week
time
to
time
Mode Time-Range Config
Format
show time-range [
name
]
Mode Privileged EXEC
Term Definition
Admin Mode The administrative mode of the time range feature
on the switch
Current number of all
Time Ranges
The number of time ranges currently configured in
the system.
Maximum number of
all Time Ranges
The maximum number of time ranges that can be
configured in the system.
To Next Page
Loading...
