NetApp CN1610 - Spanning-Tree Edgeport; No Spanning-Tree Edgeport; Spanning-Tree Forceversion; No Spanning-Tree Forceversion

324 Spanning Tree Protocol Commands
spanning-tree
edgeport
This command specifies that an interface (or range of interfaces) is an Edge Port
within the common and internal spanning tree. This allows this port to transition
to Forwarding State without delay.
no spanning-tree
edgeport
This command specifies that this port is not an Edge Port within the common and
internal spanning tree.
spanning-tree
forceversion
This command sets the Force Protocol Version parameter to a new value.
◆ Use 802.1d to specify that the switch transmits ST BPDUs rather than MST
BPDUs (IEEE 802.1d functionality supported).
◆ Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s
functionality supported).
◆ Use 802.1w to specify that the switch transmits RST BPDUs rather than
MST BPDUs (IEEE 802.1w functionality supported).
no spanning-tree
forceversion
This command sets the Force Protocol Version parameter to the default value.
Format
spanning-tree edgeport
Mode Interface Config
Format
no spanning-tree edgeport
Mode Interface Config
Default 802.1s
Format
spanning-tree forceversion {802.1d | 802.1s | 802.1w}
Mode Global Config
Format
no spanning-tree forceversion
Mode Global Config