NetApp CN1610 - Sntp Client Port; No Sntp Client Port; Sntp Unicast Client Poll-Interval;No Sntp Unicast Client Poll-Interval; Sntp Unicast Client Poll-Timeout

226 Simple Network Time Protocol Commands
sntp client port This command sets the SNTP client port ID to 0, 123 or a value between 1025
and 65535. The default value is 0, which means that the SNTP port is not
configured by the user. In the default case, the actual client port value used in
SNTP packets is assigned by the underlying OS.
no sntp client port This command resets the SNTP client port back to its default value.
sntp unicast client
poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a
power of two where
poll-interval can be a value from 6 to 10.
no sntp unicast
client poll-interval
This command resets the poll interval for SNTP unicast clients to its default
value.
sntp unicast client
poll-timeout
This command sets the poll timeout for SNTP unicast clients in seconds to a
value from 1-30.
Default 0
Format
sntp client port portid
Mode Global Config
Format
no sntp client port
Mode Global Config
Default 6
Format
sntp unicast client poll-interval poll-interval
Mode Global Config
Format
no sntp unicast client poll-interval
Mode Global Config
Default 5