NetApp CN1610 - Show Rmon Events

Chapter 4: Utility Commands 295
(CN1610) #show rmon collection history interfaces 1/0/1
Index Interface Interval Requested Granted Owner
Samples Samples
------------------------------------------------------------------
----
1 1/0/1 30 10 10 myowner
2 1/0/1 1800 50 10
monitorHistoryControl
show rmon events This command displays the entries in the RMON event table.
Format
show rmon events
Mode Privileged EXEC
Parameter Description
Event Index An index that uniquely identifies an entry in the
event table. Each such entry defines one event that is
to be generated when the appropriate conditions
occur. The range is 1 to 65535.
Event Description A comment describing the event entry. The default is
alarmEvent.
Event Type The type of notification that the probe makes about
the event. Possible values are None, Log, SNMP
Trap, Log and SNMP Trap. The default is None.
Event Owner Owner string associated with the entry. The default
is monitorEvent.
Event Community The SNMP community specific by this octet string
which is used to send an SNMP trap. The default is
public.
Owner Event owner. The owner string associated with the
entry.
Last time sent The last time over which a log or a SNMP trap
message is generated.