NetApp CN1610 - No Dot1 X Timeout

Chapter 5: Switching Commands 409
no dot1x timeout This command sets the value, in seconds, of the timer used by the authenticator
state machine on this port to the default values. Depending on the token used, the
corresponding default values are set.
tx-period The value, in seconds, of the timer used by the
authenticator state machine on this port to determine
when to send an EAPOL EAP Request/Identity
frame to the supplicant. The quiet-period must be a
value in the range 1 - 65535.
supp-timeout The value, in seconds, of the timer used by the
authenticator state machine on this port to timeout
the supplicant. The supp-timeout must be a value in
the range 1 - 65535.
server-timeout The value, in seconds, of the timer used by the
authenticator state machine on this port to timeout
the authentication server. The supp-timeout must be
a value in the range 1 - 65535.
Default
◆ guest-vlan-period: 90 seconds
◆ reauth-period: 3600 seconds
◆ quiet-period: 60 seconds
◆ tx-period: 30 seconds
◆ supp-timeout: 30 seconds
◆ server-timeout: 30 seconds
Format
dot1x timeout {{guest-vlan-period seconds } |{reauth-
period
seconds } | {quiet-period seconds } | {tx-period
seconds } | {supp-timeout seconds } | {server-timeout
seconds }}
Mode Interface Config
Tokens Definition
Format
no dot1x timeout {guest-vlan-period | reauth-period |
quiet-period | tx-period | supp-timeout | server-
timeout}