NetApp CN1610 - Show Sntp Server

Chapter 4: Utility Commands 229
show sntp server This command is used to display SNTP server settings and configured servers.
For each configured server:
Port SNTP Client Port. The field displays the value 0 if it
is default value. When the client port value is 0, if
the client is in broadcast mode, it binds to port 123;
if the client is in unicast mode, it binds to the port
assigned by the underlying OS.
Client Mode Configured SNTP Client Mode.
Term Definition
Format
show sntp server
Mode Privileged EXEC
Term Definition
Server Host Address IP address or hostname of configured SNTP Server.
Server Type Address type of server (IPv4, IPv6, or DNS).
Server Stratum Claimed stratum of the server for the last received
valid packet.
Server Reference ID Reference clock identifier of the server for the last
received valid packet.
Server Mode SNTP Server mode.
Server Maximum
Entries
Total number of SNTP Servers allowed.
Server Current Entries Total number of SNTP configured.
Term Definition
IP Address /
Hostname
IP address or hostname of configured SNTP Server.