NetApp CN1610 - Authentication Enable; No Authentication Enable; Authentication Order; No Authentication Order

Chapter 5: Switching Commands 411
authentication
enable
This command globally enables the Authentication Manager. Interface
configuration takes effect only if the Authentication Manager is enabled with this
command.
no authentication
enable
This command disables the Authentication Manager.
authentication
order
This command sets the order of authentication methods used on a port. The
available authentication methods are Dot1x, MAB, and captive portal. Ordering
sets the order of methods that the switch attempts when trying to authenticate a
new device connected to a port. If one method is unsuccessful or timed out, the
next method is attempted.
Each method can only be entered once. Ordering is only possible between 802.1x
and MAB. Captive portal can be configured either as a stand-alone method or as
the last method in the order.
no authentication
order
This command returns the port to the default authentication order.
Default disabled
Format
authentication enable
Mode Global Config
Format
no authentication enable
Mode Global Config
Format
authentication order {dot1x [mab [captive-portal] |
captive-portal] | mab [dot1x [captive-portal]| captive-
portal] | captive-portal}
Mode Interface Config
Format
no authentication order
Mode Interface Config