NetApp CN1610 - No Username Snmpv3 Authentication; Username Snmpv3 Encryption

64 User Account Commands
no username
snmpv3
authentication
This command sets the authentication protocol to be used for the specified user to
none. The username is the user name for which the specified authentication
protocol is used.
username snmpv3
encryption
This command specifies the encryption protocol used for the specified user. The
valid encryption protocols are
des or none.
If you select
des, you can specify the required key on the command line. The
encryption key
must be 8 to 64 characters long. If you select the des protocol but
do not provide a key, the user is prompted for the key. When you use the
des
protocol, the login password is also used as the snmpv3 encryption password, so
it must be a minimum of eight characters. If you select
none, you do not need to
provide a key.
The
username value is the login user name associated with the specified
encryption. You must enter the
username in the same case you used when you
added the user. To see the case of the
username, enter the show users
command.
Default no authentication
Format
username snmpv3 authentication username {none | md5 |
sha}
Mode Global Config
Format
no username snmpv3 authentication username
Mode Global Config
Default no encryption
Format
username snmpv3 encryption username {none | des [key] }
Mode Global Config