NetApp CN1610 - Lldp Med Confignotification All; Lldp Med Faststartrepeatcount; No Lldp Med Faststartrepeatcount; Lldp Med Transmit-Tlv All

Chapter 5: Switching Commands 559
lldp med
confignotification
all
Use this command to configure all the ports to send the topology change
notification.
lldp med
faststartrepeatcoun
t
Use this command to set the value of the fast start repeat count.
[count] is the
number of LLDP PDUs that will be transmitted when the product is enabled. The
range is 1 to 10.
no lldp med
faststartrepeatcoun
t
Use this command to return to the factory default value.
lldp med transmit-
tlv all
Use this command to specify which optional Type Length Values (TLVs) in the
LLDP MED set will be transmitted in the Link Layer Discovery Protocol Data
Units (LLDPDUs).
Format
lldp med confignotification all
Mode Global Config
Default 3
Format
lldp med faststartrepeatcount [count]
Mode Global Config
Format
no lldp med faststartrepeatcount
Mode Global Config
Default By default, the capabilities and network policy TLVs are included.
Format
lldp med transmit-tlv all [capabilities] [ex-pd] [ex-
pse] [inventory] [location] [network-policy]
Mode Global Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.