Chapter 5: Switching Commands 313
show port This command displays port information.
Format
show port {
intf-range
| all}
Mode Privileged EXEC
Parameter Definition
Interface slot/port
Type If not blank, this field indicates that this port is a
special type of port. The possible values are:
◆ Mirror — this port is a monitoring port. For
more information, see “Port Mirroring
Commands” on page 466.
◆ PC Mbr— this port is a member of a port-
channel (LAG).
◆ Probe — this port is a probe port.
Admin Mode The Port control administration state. The port must
be enabled in order for it to be allowed into the
network. May be enabled or disabled. The factory
default is enabled.
Physical Mode The desired port speed and duplex mode. If auto-
negotiation support is selected, then the duplex
mode and speed is set from the auto-negotiation
process. Note that the maximum capability of the
port (full duplex -100M) is advertised. Otherwise,
this object determines the port's duplex mode and
transmission rate. The factory default is Auto.
Physical Status The port speed and duplex mode.
Link Status The Link is up or down.
Link Trap This object determines whether or not to send a trap
when link status changes. The factory default is
enabled.
LACP Mode LACP is enabled or disabled on this port.
To Next Page
Loading...
