NetApp CN1610 - Enable Password (Privileged EXEC)

72 User Account Commands
(CN1610) #configure
(CN1610) (Config)#aaa ias-user username 1f3ccb1157
(CN1610) (Config-aaa-ias-User)#password 1f3ccb1157
(CN1610) (Config-aaa-ias-User)#exit
(CN1610) (Config)#
enable password
(Privileged EXEC)
Use the enable password configuration command to set a local password to
control access to the privileged EXEC mode.
The following shows an example of the command.
(Switching) #enable password testtest
(Switching) #enable password
e8d63677741431114f9e39a853a15e8fd35ad059e2e1b49816c243d7e08152b052
eafbf23b528d348cdba1b1b7ab91be842278e5e970dbfc62d16dcd13c0b864
encrypted
(Switching) #enable password
Enter old password:********
Enter new password:********
Confirm new password:********
Format
enable password [ password [encrypted]]
Mode Privileged EXEC
Parameter Description
password Password string. Range: 8-64 characters.
encrypted Encrypted password you entered, copied from
another switch configuration. The encrypted
password should be 128 characters long because the
assumption is that this password is already
encrypted with AES.