NetApp CN1610 - No Lacp Actor Admin State; Lacp Actor Port Priority

Chapter 5: Switching Commands 449
Note
This command is applicable only to physical interfaces.
no lacp actor admin
state
Use this command the configure the default administrative values of actor state as
transmitted by the Actor in LACPDUs.
Note
Both the no portlacptimeout and the no lacp actor admin state commands
set the values back to default, regardless of the command used to configure the
ports. Consequently, both commands will display in
show running-config .
lacp actor port
priority
Use this command to configure the priority value assigned to the Aggregation
Port for an interface or range of interfaces. The valid range for
priority is 0 to
65535.
Note
This command is applicable only to physical interfaces.
Default 0x07
Format
lacp actor admin state {individual|longtimeout|passive}
Mode Interface Config
Format
no lacp actor admin state
{individual|longtimeout|passive}
Mode Interface Config
Default 0x80
Format
lacp actor port priority 0-65535
Mode Interface Config