NetApp CN1610 - No Dhcp L2 Relay Vlan; Show Dhcp L2 Relay All

480 DHCP L2 Relay Agent Commands
no dhcp l2relay vlan Use this command to disable the DHCP L2 Relay agent for a set of VLANs.
show dhcp l2relay
all
This command displays the summary of DHCP L2 Relay configuration.
The following shows example CLI display output for the command.
(Broadcom FASTPATH Switching) #show dhcp l2relay all
DHCP L2 Relay is Enabled.
Interface L2RelayMode TrustMode
---------- ----------- --------------
0/2 Enabled untrusted
0/4 Disabled trusted
VLAN Id L2 Relay CircuitId RemoteId
--------- ---------- ----------- ------------
3 Disabled Enabled --NULL--
5 Enabled Enabled --NULL--
6 Enabled Enabled broadcom
7 Enabled Disabled --NULL--
Format
dhcp l2relay vlan vlan-list
Mode Global Config
Parameter Description
vlan–list The VLAN ID. The range is 1–4093. Separate
nonconsecutive IDs with a comma (,) no spaces and
no zeros in between the range. Use a dash (–) for the
range.
Format
no dhcp l2relay vlan vlan-list
Mode Global Config
Format
show dhcp l2relay all
Mode Privileged EXEC