NetApp CN1610 - Dot1 X Port-Control; No Dot1 X Port-Control; Dot1 X Port-Control All

Chapter 5: Switching Commands 405
dot1x port-control This command sets the authentication mode to use on the specified interface or
range of interfaces. Use the
force-unauthorized parameter to specify that the
authenticator PAE unconditionally sets the controlled port to unauthorized. Use
the
force-authorized parameter to specify that the authenticator PAE
unconditionally sets the controlled port to authorized. Use the
auto parameter to
specify that the authenticator PAE sets the controlled port mode to reflect the
outcome of the authentication exchanges between the supplicant, authenticator
and the authentication server. If the
mac-based option is specified, then MAC-
based dot1x authentication is enabled on the port.
no dot1x port-
control
This command sets the 802.1X port control mode on the specified port to the
default value.
dot1x port-control
all
This command sets the authentication mode to use on all ports. Select
force-
unauthorized
to specify that the authenticator PAE unconditionally sets the
controlled port to unauthorized. Select
force-authorized to specify that the
authenticator PAE unconditionally sets the controlled port to authorized. Select
auto to specify that the authenticator PAE sets the controlled port mode to
reflect the outcome of the authentication exchanges between the supplicant,
authenticator and the authentication server. If the
mac-based option is specified,
then MAC-based dot1x authentication is enabled on the port.
Default auto
Format
dot1x port-control {force-unauthorized | force-
authorized | auto | mac-based}
Mode Interface Config
Format
no dot1x port-control
Mode Interface Config
Default auto
Format
dot1x port-control all {force-unauthorized | force-
authorized | auto | mac-based}
Mode Global Config