Chapter 6: IPv6 IPv6 Management Commands 595
no network ipv6
enable
Use this command to disable IPv6 operation on the network port.
serviceport ipv6
address
Use the options of this command to manually configure IPv6 global address,
enable/disable stateless global address autoconfiguration and to enable/disable
dhcpv6 client protocol information on the service port.
Multiple IPv6 prefixes can be configured on the service port.
no serviceport ipv6
address
Use the command no serviceport ipv6 address to remove all configured
IPv6 prefixes on the service port interface.
Use the command with the address option to remove the manually configured
IPv6 global address on the network port interface.
Use the command with the autoconfig option to disable the stateless global
address autoconfiguration on the service port.
Format
no network ipv6 enable
Mode Privileged EXEC
Format
serviceport ipv6 address {
address/prefix-length
[eui64]|autoconfig|dhcp}
Mode Privileged EXEC
Parameter Description
address IPv6 prefix in IPv6 global address format.
prefix-length IPv6 prefix length value.
eui64 Formulate IPv6 address in eui64 address format.
autoconfig Configure stateless global address autoconfiguration
capability.
dhcp Configure dhcpv6 client protocol.
To Next Page
Loading...
