NetApp CN1610 - Set Mld Mrouter Interface; No Set Mld Mrouter Interface; Show Mldsnooping

Chapter 5: Switching Commands 529
set mld mrouter
interface
Use this command to configure the interface as a multicast router-attached
interface. When configured as a multicast router interface, the interface is treated
as a multicast router-attached interface in all VLANs.
no set mld mrouter
interface
Use this command to disable the status of the interface as a statically configured
multicast router-attached interface.
show mldsnooping Use this command to display MLD Snooping information. Configured
information is displayed whether or not MLD Snooping is enabled.
When the optional arguments
unit/slot/port or vlanid are not used, the
command displays the following information.
Format
no set mld mrouter vlanid
Mode Interface Config
Default disabled
Format
set mld mrouter interface
Mode Interface Config
Format
no set mld mrouter interface
Mode Interface Config
Format
show mldsnooping [unit/slot/port | vlanid]
Mode Privileged EXEC
Term Definition
Admin Mode Indicates whether or not MLD Snooping is active on
the switch.