NetApp CN1610 - Length Value; No Length Value; Terminal Length; No Terminal Length

Chapter 4: Utility Commands 185
length value Use this command to set the pagination length to value number of lines for the
sessions specified by configuring on different Line Config modes
(telnet/ssh/console) and is persistent.
Length command on Line Console mode applies for Serial Console session.
no length
value Use this command to set the pagination length to the default value number of
lines.
terminal length Use this command to set the pagination length to value number of lines for the
current session. This command configuration takes an immediate effect on the
current session and is nonpersistent.
no terminal length Use this command to set the value to the length value configured on Line Config
mode depending on the type of session.
Mode Privileged EXEC
Default
24
Format
length value
Mode Line Config
Format
no length value
Mode Line Config
Default 24 lines per page
Format
terminal length value
Mode Privileged EXEC
Format
no terminal length value
Mode Privileged EXEC