NetApp CN1610 - No Vlan Pvid; Vlan Tagging; No Vlan Tagging; Vlan Association Subnet

Chapter 5: Switching Commands 361
no vlan pvid This command sets the VLAN ID on an interface or range of interfaces to 1.
vlan tagging This command configures the tagging behavior for a specific interface or range of
interfaces in a VLAN to enabled. If tagging is enabled, traffic is transmitted as
tagged frames. If tagging is disabled, traffic is transmitted as untagged frames.
The ID is a valid VLAN identification number.
no vlan tagging This command configures the tagging behavior for a specific interface or range of
interfaces in a VLAN to disabled. If tagging is disabled, traffic is transmitted as
untagged frames. The ID is a valid VLAN identification number.
vlan association
subnet
This command associates a VLAN to a specific IP-subnet.
Default 1
Format
vlan pvid 1-4093
Mode Interface Config
Interface Range Config
Format
no vlan pvid
Mode Interface Config
Format
vlan tagging 1-4093
Mode ◆ Interface Config
Format
no vlan tagging 1-4093
Mode ◆ Interface Config
Format
vlan association subnet ipaddr netmask vlanid
Mode VLAN Config