NetApp CN1610 - BCM Shell Command

274 BCM Shell Command
BCM Shell Command
The BCM (SDK) shell is mainly used for debugging the Broadcom SDK. BCM
shell commands can be executed directly from the CLI without entering the BCM
shell itself by using the keyword
drivshell before the BCM command.
However, you can also enter the BCM shell to directly execute any of the BCM
commands on the shell using the
bcmsh command.
bcmsh
The bcmsh command is used to enter into the BCM shells from Privileged EXEC
mode. Only users with Level 15 permissions can execute this command.
Management is blocked during this mode; the user is notified and asked whether
to continue. This command is only supported on the serial console and not via
telnet/ssh.
Note
To exit the shell and return to the CLI, enter exit .
Format
bcmsh
Mode Privileged EXEC