NetApp CN1610 - Serial Baudrate; No Serial Baudrate; Serial Timeout; No Serial Timeout;Show Serial

Chapter 3: Management Commands 39
serial baudrate This command specifies the communication rate of the terminal interface. The
supported rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
no serial baudrate
This command sets the communication rate of the terminal interface.
serial timeout This command specifies the maximum connect time (in minutes) without console
activity. A value of 0 indicates that a console can be connected indefinitely. The
time range is 0 to 160.
no serial timeout This command sets the maximum connect time (in minutes) without console
activity.
show serial This command displays serial communication settings for the switch.
Default 9600
Format
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 |
38400 | 57600 | 115200}
Mode Line Config
Format
no serial baudrate
Mode Line Config
Default 5
Format
serial timeout 0-160
Mode Line Config
Format
no serial timeout
Mode Line Config
Format
show serial