34 Network Interface Commands
Default Gateway The default gateway for this IP interface. The
factory default value is 0.0.0.0.
IPv6 Administrative
Mode
Whether enabled or disabled.
IPv6 Prefix is The IPv6 address and length. Default is Link Local
format.
Burned In MAC
Address
The burned in MAC address used for in-band
connectivity.
Locally Administered
MAC Address
If desired, a locally administered MAC address can
be configured for in-band connectivity. To take
effect, 'MAC Address Type' must be set to 'Locally
Administered'. Enter the address as twelve
hexadecimal digits (6 bytes) with a colon between
each byte. Bit 1 of byte 0 must be set to a 1 and bit 0
to a 0, i.e. byte 0 should have the following mask
'xxxx xx10'. The MAC address used by this bridge
when it must be referred to in a unique fashion. It is
recommended that this be the numerically smallest
MAC address of all ports that belong to this bridge.
However it is only required to be unique. When
concatenated with dot1dStpPriority a unique Bridge
Identifier is formed which is used in the Spanning
Tree Protocol.
MAC Address Type The MAC address which should be used for in-band
connectivity. The choices are the burned in or the
Locally Administered address. The factory default is
to use the burned in MAC address.
Configured IPv4
Protocol
The IPv4 network protocol being used. The options
are bootp | dhcp | none.
Configured IPv6
Protocol
The IPv6 network protocol being used. The options
are dhcp | none.
Term Definition
To Next Page
Loading...
