NetApp CN1610 - Page 443

440 Storm-Control Commands
The following shows example CLI display output for the command.
(CN1610) #show storm-control
(CN1610) #show storm-control
Broadcast Storm Control Mode................... Disable
Broadcast Storm Control Level.................. 5 percent
Multicast Storm Control Mode................... Disable
Multicast Storm Control Level.................. 5 percent
Unicast Storm Control Mode..................... Disable
Unicast Storm Control Level.................... 5 percent
The following shows example CLI display output for the command.
(CN1610) #show storm-control 0/1
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- -------- ------- -------- ------- --------
0/1 Disable 5% Disable 5% Disable 5%
The following shows an example of part of the CLI display output for the
command.
(CN1610) #show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast
Parameter Definition
Bcast Mode Shows whether the broadcast storm control mode is
enabled or disabled. The factory default is disabled.
Bcast Level The broadcast storm control level.
Mcast Mode Shows whether the multicast storm control mode is
enabled or disabled.
Mcast Level The multicast storm control level.
Ucast Mode Shows whether the Unknown Unicast or DLF
(Destination Lookup Failure) storm control mode is
enabled or disabled.
Ucast Level The Unknown Unicast or DLF (Destination Lookup
Failure) storm control level.