Chapter 4: Switching 63
Defaults ISDP is enabled by default.
Configuration
example
The following example configures ISDP timer and hold values, enables sending
ISDPv2 packets, enables ISDP globally, and then enables it on an interface:
For more information on the ISDP commands, see the CN1610 Network Switch
CLI Command Reference.
Platform Contains an ASCII character string that describes the
hardware platform of the device. The TLV length field
determines the length of the string.
On the CN1610 switch, this string is populated with the
machine model of the device.
(CN1610) #configure
(CN1610) (Config)#isdp timer 120
(CN1610) (Config)#isdp holdtime 60
(CN1610) (Config)#isdp advertise-v2
(CN1610) (Config)#isdp run
(CN1610) (Config)#interface 0/5
(CN1610) (Interface 0/5)#isdp enable
To Next Page
