7) Setup process is now complete!
Configuring with a computer (Mac/Windows/Linux)
1) Open your computer’s web-browser and go to: “welcome.netatmo.com”. You will be able to
download the WELCOME installer.
You need internet access for this operation.
2) Plug the camera to your computer with the the provided short USB cable. WELCOME’s LED
shines green during all the booting process. Then this light turns into a glowing white, meaning
the camera has been detected by your computer.
WARNING: When you configure your Netatmo WELCOME camera with a computer DO NOT
unplug the camera unless asked to.
3) Follow setup steps detailed in the installer. Light glowing will stop when setup process begins.
4) When asked in the installer, (the white light should have restarted to glow) you will be able to
unplug the camera, and place it wherever you wish in your home. You need now the provided
USB power wall adapter to power WELCOME.
5) Setup process is now complete!
When you configure your Netatmo WELCOME camera with a computer, the camera is not
connected to the wall adapter. It is only connected to the computer using the provided USB
cable (USB to micro-USB). No additional cable is needed.
Power supply
To Next Page
Loading...
General