14 of 22
CloudMesh Satellite – User Guide
UG01350 v1.00 14 July 2021
If the CloudMesh Satellite is paired to a CloudMesh Gateway, you can access the web interface by typing its
unique hostname into the address bar of a web browser.
The unique hostname for each CloudMesh Satellite is defined in the following format:
http://NS-02-XXXX.local
Where XXXX is the last four digits of the Satellite’s unique serial number.
The CloudMesh Satellite’s serial number can be found on the label affixed to the bottom:
F i gure 9 – Last four digits of the serial number
If the device is not paired, please first follow
Appendix B – Set Cl oudMesh S atellite I P to a ccess web interface
to
set up a static IP for the Satellite and then continue from step 3b of this section, below.
To access the Satellite’s web interface:
1 Connect the supplied power adapter to the power port on the CloudMesh Satellite and plug the
power adapter into a power point. Turn on the power at the wall and allow 60 – 90 seconds for the
satellite to power up.
2 Connect the supplied Ethernet cable from one of the two yellow LAN ports on the bottom of the
CloudMesh Satellite to an Ethernet port on your computer.
To Next Page
Loading...