TROUBLE SHOOTING
My Powerline Adapters Will Not Connect To Each Other
1. Hold down the Simple Connect button on the rst device for 15 seconds, or until the
LEDs ash, then hold the Simple Connect on the second device for 3 seconds and
nally hold the Simple Connect button on the rst device for 3 seconds.
2. The network password has now been reset and both adapters will be able to
communicate with each other.
3. To make this process easier it is recommended that both Adapters are connected to a
powerpoint near each other or in the same room.
QSG 00056 rev1
1 1
For any technical support enquiries please contact the
NetComm technical support team on
www.netcommwireless.com/contact-forms/support
to ll out an online enquiry or alternatively call
(02) 9424 2059
To Previous Page
Loading...
