Netgate Netgate-6100

To Next Page

To Previous Page

Security Gateway Manual Netgate-6100

9. After a few seconds, a message will indicate the Setup Wizard has completed. To proceed to the pfSense

Plus

dashboard, click Finish.

10. A ﬁnal notiﬁcation screen will appear with the Copyright and Trademark Notices. Read and click Accept

to continue to the dashboard.

Fig. 7: Read and Click Accept

If you unplugged the Ethernet cable at the beginning of this conﬁguration, reconnect it to the WAN1 port now.

This completes the basic conﬁguration for the Netgate appliance.

Netgate Netgate-6100 - Page 9