Security Gateway Manual SG-1100
2. Write the image to a USB memstick. Locating the image and writing it to a USB memstick is covered in detail
under Writing Flash Drives.
3. Connect to the console port of the Netgate device.
4. Insert the memstick into the USB port and boot the system.
Tip: Best practice is to turn off the system, insert the USB memstick, ensure you have console access, and
reboot the system. You will need to interrupt the boot process very soon after initial boot.
5. When prompted, press any key to stop the autoboot process.
6. Type run usbrecovery at the Marvell>> prompt and press Enter.
7. Select the destination device by pressing Enter, then confirm by pressing y and Enter.
Note: The onboard eMMC flash memory is always mmcsd0.
8. Wait for the installation to the eMMC to complete.
9. Once the install has completed, remove the memstick, and cycle the power (unplug the SG-1100 and plug it
back in) to reboot the SG-1100.
Note: For information on restoring from a previously saved configuration, go to Backup and Restore.
© Copyright 2020 Rubicon Communications LLC 26
To Next Page
Loading...
