Security Gateway Manual SG-1100
5. Check tagged for Member 1, then click Save.
6. Click on the button for VLAN group 2.
7. Click on the Add member button, Enter Member 1, check tagged and then click Save.
8. Click on the button for VLAN group 1.
9. Click on the Add member button, Enter Member 1, check tagged and then click Save.
10. Click on the Ports tab.
11. Click on the Port VID for OPT. Change the default value 4092 to 1. In the lower right-hand corner click Save.
When completed the Ports and VLANs configuration should reflect the screenshots below:
You can now connect a managed switch (VLANs 4090-4092 must be trunked on the switchport of the managed switch)
to OPT with VLANs 4090 (WAN), 4091 (LAN), and 4092 (OPT) tagged to it.
If you need access to the WebConfigurator on LAN, you can just connect a laptop to LAN and you should receive a
DHCP lease (unless DHCP Server on LAN has been disabled). You will also be able to access the WebGUI (unless
the default Anti-Lockout Rule has been disabled) and internet (unless the Default allow LAN to any rule has been
disabled).
© Copyright 2020 Rubicon Communications LLC 31
To Next Page
Loading...
