Security Gateway Manual SG-1100
Warning: VLAN group 0 must remain in place and VLAN groups 1-3 must include 0t as a member, in
order to function properly.
7. Click Delete for Member 1, then click Save.
8. Click on the button on VLAN group 2.
9. Click on the Add member button. Enter Member 1, uncheck tagged and then click Save.
10. Confirm the configuration matches the screenshots below:
Note: Unlike software bridging, traffic between ports 1 and 2 will never leave the switch chip so it will perform at
switching speed. You also cannot filter traffic between the two ports as pfSense will never see it, just like with any
other (external) switch.
© Copyright 2020 Rubicon Communications LLC 49
To Next Page
Loading...
