Name: Netgate SG-3100
Brand: Netgate
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Security Gateway Manual SG-3100

1.2 Initial Conﬁguration

Plug the power cable into the power port (shown in the Input and Output Ports section) to turn on the Netgate®

Firewall. Allow 4 or 5 minutes to boot up completely.

Warning: If the CPE on WAN (e.g. DSL or Cable Modem) has a default IP Address of 192.168.1.1,

disconnect the Ethernet cable from the WAN port on the Netgate 3100 Security Gateway before proceeding.

Change the default LAN IP Address of the device during a later step in the conﬁguration to avoid having conﬂicting

subnets on the WAN and LAN.

1. From the computer, log into the web interface

Open a web browser (Google Chrome in this example) and enter 192.168.1.1 in the address bar. Press

Enter.

Fig. 1: Enter the Default LAN IP Address

2. A warning message may appear. If this message or similar message is encountered, it is safe to proceed. Click

the Advanced Button and then click Proceed to 192.168.1.1 (unsafe) to continue.

Fig. 2: Click Advanced and then Proceed to 192.168.1.1 (unsafe)

3. At the Sign In page, enter the default pfSense

Plus username and password and click Next.

• Default Username: admin

Questions and Answers:

Need help?

Do you have a question about the Netgate SG-3100 and is the answer not in the manual?

Netgate SG-3100 Specifications

General