Security Gateway Manual XG-7100-1U
Note: Options such as the type of disk partition can be modified through this installation if required.
8. The installer will then prompt to choose the type of system being installed, which pre-configures device-specific
defaults. Choose the option that exactly matches the unit being reinstalled. If the model is unknown, check the
sticker on the bottom of the unit.
9. Once the installer is finished, choose No and press Enter to skip going to a shell.
10. The installer will then prompt to Reboot the system. Select Reboot and press Enter. The system will shutdown
and reboot.
Dec 21 22:41:37 Waiting (max 60 seconds) for system process `vnlru` to stop... d
one
Waiting (max 60 seconds) for system process `syncer` to stop...
Waiting (max 60 seconds) for system process `bufdaemon` to stop... done
All buffers synced.
Uptime: 5m43s
umass0: detached
11. Remove the USB drive from the USB port. pfSense will restart automatically. If the USB drive remains
attached, the system will boot into the installer again because by default the system firmware is configured so
that a device plugged into the USB port will be booted with a higher priority.
Note: For information on restoring from a previously saved configuration, go to Backup and Restore.
© Copyright 2020 Rubicon Communications LLC 52
To Next Page
Loading...
