NETGEAR AirCard 790

Advanced Settings
87
AirCard 790S Mobile Hotspot
Note: PDP roaming protocol is the IP protocol used while you are roaming
(for example when you are traveling and the roaming network does
not support IPv6).
11. Click the + symbol next to the new
APN entry.
The entry is added to the table.
 To select the APN to use:
1. From a computer or wireless device that is connected to your network, launch an
Internet browser
.
2. Enter http://netgear
.aircard or http://192.168.1.1.
Your device might have a different web page address. To get the web page address for
your device, tap Settings > More > Device Information >
AC790 Manager or look at the
label underneath the device battery.
A login screen displays.
3. Enter the administrator login password.
The default password is admin.
The password is case-sensitive.
The Home screen displays.
4. Select Settings > Network >
APN.
5. Select the Active radio button next to the APN entry to be used.
The APN is selected.
 To remove an APN entry:
1. From a computer or wireless device that is connected to your network, launch an
Internet browser
.
2. Enter http://netgear
.aircard or http://192.168.1.1.
Your device might have a different web page address. To get the web page address for
your device, tap Settings > More > Device Information >
AC790 Manager or look at the
label underneath the device battery.