NETGEAR CG4500BD

Manage and Monitor Your Network
83
AC1900, N900, and N450 WiFi Cable Data Gateways
6. In the Internet Port pane, click the Show Statistics button.
The Show Statistics pop-up screen displays.
If this screen does not display, your web browser might be blocking pop-ups. If it is,
change the browser settings to allow pop-ups. The cable data gateway could also block
pop-ups. For information about allowing pop-ups on the cable data gateway, see Manage
Firewall, Web, and NAT ALG Security on page 73.
The following table describes the fields and columns of the Show Statistics pop-up
screen.
Field or Column Description
System Up Time The time elapsed since the cable data gateway was last restarted.
Port The statistics for the WAN port (that is, the cable Internet port that connects to the
Internet), LAN (Ethernet) ports, and WLAN (WiFi) ports. For each port, the screen
displays the information that is described in this table.
The link status of the port.
The number of packets transmitted on this port since reset or manual clear.
The number of packets received on this port since reset or manual clear.
The number of collisions on this port since reset or manual clear.
The current transmission (outbound) bandwidth used on the WAN and LAN ports.
The current reception (inbound) bandwidth used on the WAN and LAN ports.
The time elapsed since this port acquired the link.
Poll Interval The interval at which the statistics are updated in this screen.
Status
TxPkts
RxPkts
Collisions
Tx B/s
Rx B/s
Up Time