Reference Manual for the Model DG834PN 108 Mbps RangeMax
TM
Wireless ADSL Modem Router
7-10 Advanced Configuration
August 2005
• Your company’s network is 134.177.0.0.
When you first configured your router, two implicit static routes were created. A default route was
created with your ISP as the wireless ADSL modem router, and a second static route was created
to your local network for all 192.168.0.x addresses. With this configuration, if you attempt to
access a device on the 134.177.0.0 network, your router will forward your request to the ISP. The
ISP forwards your request to the company where you are employed, and the request will likely be
denied by the company’s firewall.
In this case you must define a static route, telling your router that 134.177.0.0 should be accessed
through the ISDN router at 192.168.0.100. The static route would look like Figure 7-6.
In this example:
• The Destination IP Address and IP Subnet Mask fields specify that this static route applies to
all 134.177.x.x addresses.
• The Wireless ADSL Modem Router IP Address fields specifies that all traffic for these
addresses should be forwarded to the ISDN router at 192.168.0.100.
• A Metric value of 1 will work since the ISDN router is on the LAN.
This represents the number of routers between your network and the destination. This is a
direct connection so it is set to 1.
• Private is selected only as a precautionary security measure in case RIP is activated.
How to Configure Static Routes
1. Log in to the router at its default LAN address of http://192.168.0.1 with its default User Name
of admin, default password of password, or using whatever User Name, Password and LAN
address you have chosen for the router.
2. From the Main Menu of the browser interface, under Advanced, click Static Routes to view
the Static Routes menu, shown in Figure 7-5.
To Next Page
Loading...
