EasyManuals Logo

NETGEAR DGN1000 Quick Install Guide

NETGEAR DGN1000
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Hardware Setup
Aer removing the Routers from there packaging and placing them in a suitable
locaon, you are ready to plug them in. The Sharedband Routers can be set up in
two conguraons.
The recommended setup is to connect the Routers
together via an unmanaged switch.
Or plug both Sharedband Routers together
with an Ethernet cable.
Aer connecng the Sharedband Routers together the next step is to connect them
to the phone line. This is done with the thin grey cable found too in the box for each
Router. Please ensure you are only using one microlter per line or connecng di-
rectly to the master socket.
With the Routers connected together and to the phone line they are ready to be
turned on. Plug the power lead into the back of the Router and into the nearest
power outlet.
Soware Setup
Now the Routers are powered on its me to congure the ADSL details. You should
have received the details when your ISP installed your lines or when you signed. If
your unable to locate the details, call your ISP and request the ADSL log in details.
Netgear DG834v4 QIG 2 www.sharedband.com
Using a PC connected directly into either one of the Sharedband Routers or the
Switch if you used one, open a web browser and go to this address.
hp://192.168.3.1/
You will be presented with a log in screen. The defaults are:
Username:- “admin”
Password:- “Bonding123”
(You should change the password once setup is complete)
When you have logged in you will noce on the page down the le side is a blue
menu bar. In this menu navigate to the “Basic Sengs” page.
On this page is where enter your ADSL log in details. You will need to select
“PPPoA” from the drop down box (unless your paper work from your ISP dictates
otherwise). Then in the following two boxes enter your ADSL Username and Pass-
word.
Under Internet IP address select
“Get Dynamically From ISP” and
click Apply at the boom of the
page. The Router should now be
connected to the Internet. This will
be indicated by the LEDs on the
front of the router.
Next click on “Conguraon” (under
the Sharedband secon). Ensure
there are details on this page and
the Sharedband service is enabled
before clicking the buon marked
“Save”. When prompted you will be
asked to click “Reboot”. This will restart the router.
Repeat this for the other Routers. Each router has dierent IP address. Which cor-
responds with the number wrien on the base of the Router. For example router
two will be hp://192.168.3.2, Router 3 will be hp://192.168.3.3, etc.
www.sharedband.com 3 Netgear DG834v4 QIG

Other manuals for NETGEAR DGN1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR DGN1000 and is the answer not in the manual?

NETGEAR DGN1000 Specifications

General IconGeneral
Wireless Standard802.11b/g/n
Frequency Band2.4 GHz
Wireless SpeedUp to 150 Mbps
LAN Ports4 x 10/100 Mbps
WAN Port1 x ADSL2+
SecurityWEP, WPA, WPA2
FirewallSPI, NAT
AntennaInternal
Weight0.6 lbs

Related product manuals