19
I completed the NETGEAR genie smart setup, but my wireless
devices cannot get the IP address from the extender. What
should I do?
Make sure that the passphrase you entered on your wireless device
is correct, and power cycle the extender and your router. If your
device is still not able to get the IP address, try these tips:
• Move the extender closer to your router and move your
wireless device closer to the extender.
• Disable the wireless interface and enable it again to see if your
wireless device can get the IP address.
• If your router has a MAC filter (wireless access control), follow
the instructions on page 18.
To Next Page
Loading...
