Install the Switch and Connect the Other
Devices
1. Place the switch on a flat surface or hook onto the screws.
2. For each device, insert one end of an Ethernet cable into the port in the device and insert
the other end into one of the Ethernet ports on the switch.
Note: If you have more than 5 devices to connect to this switch, you must connect
them to a hub or other switch and then connect that hub or switch to this switch.
3. Connect the power adapter’s cord into the back of the switch and then plug the adapter
into a power source (such as a wall socket or power strip).
The Power light should light up.
The corresponding port number for each
connected and powered device should light and
flash when activity occurs: green for 100 Mbps
connections and yellow for 10 Mbps connections.
Note: If any light doesn’t operate as indicated, go to the Troubleshooting section.
To Next Page
Loading...
