Model GA620 Gigabit Ethernet Card Installation Guide for Windows NT
9. Click on “OK” to accept the changed parameters.
The Network window opens.
10. Click on “Close.”
If other cards in your server use TCP/IP bindings, the Microsoft TCP/IP
Properties window opens. Set any necessary TCP/IP configurations, and
then click on “OK” when finished.
11. Click on “Yes” when prompted to restart your computer.
The system restarts using the new driver and configuration settings.
To configure Link negotiation, RX (receive) flow control, or TX (transmit) flow
control card parameters:
1. From the Start Menu on the Windows desktop, select “Settings” and
then “Control Panel.”
The Control Panel window opens.
2. Double-click on the Network icon.
The Network window opens.
3. Click on the “Adapters” tab.
4. Click on “NETGEAR GA620 Gigabit Ethernet Card,” and then click
on “Properties.”
The Properties window opens.
5. Click on the parameter boxes to disable (not selected) or enable
(selected) the parameter.
6. Click on “OK” to accept the settings.
Changing Configuration Parameters
To Next Page
Loading...
