Why does my NETGEAR Network Card pass tests only after removing other cards?
If the NETGEAR Network Card passes the tests after removing all other network cards from the system, it suggests that the other cards might be causing contention. In this case, the suggested solution is to remove all other network cards from the system and run the tests again.
What to do if replacing my NETGEAR GA620 fixes the issue?
If the second card works in the slot where the first NETGEAR Network Card failed, the original card is probably defective. The solution is to replace the failed network card with one that is known to work properly.
What to do if external loopback test fails on NETGEAR Network Card?
If the external loopback test fails, make sure that your system is using a loopback cable connecting the RX port to the TX port on the NETGEAR Network Card.
How to troubleshoot NETGEAR Network Card test result problems?
If the test results indicate a possible problem with the NETGEAR Network Card, try reinstalling the card or moving it to a different slot or to a different system. Then run the DDTP tests again.
General| Brand | NETGEAR |
|---|---|
| Model | GA620 |
| Category | Network Card |
| Language | English |
To Next Page
