Reference Guide for the Model GA620 Gigabit Ethernet Card
Novell NetWare Driver Software 4-9
Following is a sample listing of a valid autoexec.ncf file. One set of load and bind commands
(in boldface type) is added for each frame type the card is configured to support.
set Time Zone = PST8PDT
set Daylight Savings Time Offset = 1:00:00
set Start Of Daylight Savings Time = (APRIL SUNDAY FIRST 2:00:00 AM)
set End Of Daylight Savings Time = (OCTOBER SUNDAY LAST 2:00:00 AM)
set Default Time Server Type = SINGLE
# Note: The Time zone information mentioned above
# should always precede the SERVER name.
set Bindery Context = O=NETGEAR
file server name MARS
ipx internal net 34881EEE
load conlog maximum=100
; Network driver LOADs and BINDs are initiated via
; INITSYS.NCF. The actual LOAD and BIND commands
; are contained in INITSYS.NCF and NETINFO.CFG.
; These files are in SYS:ETC.
sys:etc\initsys.ncf
load GA620 slot=
4
frame=
Ethernet_802.2
name=
GA620_1_e82
bind ipx
GA620_1_e82
net=
aaaa
mount all
set immediate purge of deleted files = on
set upgrade low priority threads = on
set display spurious interrupt alerts = on
set display lost interrupt alerts = on
Table 4-2 describes the parameters that can be defined in the load statements.
Table 4-2. Load Parameters
Parameter Descriptions
slot=n Identifies the slot number for the specific network card currently being
configured. This parameter is not necessary if only a single network card is
installed.
frame=type Defines the frame type being used by this load instance. Valid types are:
• Ethernet_802.2
• Ethernet_802.3
• Ethernet_ii
• Ethernet_snap
Novel.fm Page 9 Monday, November 23, 1998 1:04 PM
To Next Page
Loading...
