How to fix NETGEAR Wireless Router if power light not on?
If your NETGEAR Wireless Router's power light is not on, ensure the power cord is properly connected to both the router and a functioning power outlet. Also, verify that you are using the 5 V DC 1A power adapter supplied by NETGEAR for this product.
What to do if my NETGEAR Wireless Router is unable to access the Internet?
To resolve the issue where your NETGEAR Wireless Router cannot access the Internet: * Power off your cable or DSL modem. * Power off your router. * Wait five minutes, then reapply power to the modem. * Once the modem has reacquired sync with your ISP, reapply power to your router. * Finally, restart your computer.
Why are the LAN or Internet Port Lights not on my NETGEAR KWGR614?
If the LAN or Internet port lights on your NETGEAR Wireless Router are not lit, take the following steps: * Ensure the Ethernet cable connections are securely plugged into both the router and the connected hub or workstation. * Verify that the connected hub or workstation is powered on. * Confirm that you are using the correct type of Ethernet cable.
What to do if my NETGEAR KWGR614 Wireless Router is still unable to obtain an IP address from the ISP?
If your NETGEAR Wireless Router is still unable to obtain an IP address from your ISP: * Check with your ISP to see if they require PPP over Ethernet (PPPoE) or another login type. * If a login is required, verify that you have correctly entered the login name and password. * Enter the Host Name of your ISP account as the Account Name in the Basic Settings menu. * Inform your ISP that you have a new network device and provide them with the router’s MAC address. * Configure your router to spoof your computer’s MAC address.
What to do if the path is not functioning correctly on NETGEAR KWGR614?
To fix a path that is not functioning correctly on your NETGEAR Wireless Router: * Make sure the LAN port LED is on. * Check that the corresponding Link LEDs are on for your network interface card and for the hub ports connected to your workstation and router. * Verify that the Ethernet card driver software and TCP/IP software are installed and configured on your computer or workstation. * Verify that the IP address for your router and your workstation are correct and on the same subnet.
Why my NETGEAR KWGR614 does not save changes in the Web Configuration Interface?
If your NETGEAR Wireless Router does not save changes in the Web Configuration Interface, make sure to click 'Apply' before navigating to another menu or tab. Also, try clicking the 'Refresh' or 'Reload' button in your web browser.
What does it mean if the Test Light Stays Amber on NETGEAR KWGR614 Wireless Router?
If the test light on your NETGEAR Wireless Router stays amber, it indicates a fault within the router. Try cycling the power to see if the router recovers. If that doesn't work, clear the router’s configuration to factory defaults. This will set the router’s IP address to www.routerlogin.net.
What to do if ISP could be rejecting the Ethernet MAC addresses of NETGEAR KWGR614 Wireless Router?
Configure your NETGEAR Wireless Router to “clone” or “spoof” the MAC address from the authorized computer.
General| Wireless Standard | 802.11g |
|---|---|
| Frequency Band | 2.4 GHz |
| Maximum Wireless Speed | 54 Mbps |
| Ethernet Ports | 4 |
| Security | WEP, WPA, WPA2 |
| Weight | 0.5 lbs |
| Antennas | 2 |
To Next Page
