Reference Manual for the Model MR814 Wireless Router
3-12 Preparing Your Network
Restarting the Network
Once you’ve set up your computers to work with the router, you must reset the network for the
devices to be able to communicate correctly.
1. Turn off the DSL or cable modem, wait 15 seconds, and then turn it on again
2. Turn off the router, and then turn it on again and wait about 10 seconds until the Test light
turns off.
3. Restart any computer that is connected to the router.
Note: If the modem doesn’t have an on/off switch pull the modem’s power adapter out of the wall
socket or power strip.
Ready for Configuration
After configuring all of your computers for TCP/IP networking and connecting them to the local
network of your Model MR814 router, you are ready to access and configure the router. Proceed to
the next chapter.
To Next Page
Loading...
