To cable your router:
1.
Unplug your modem’s power, leaving the modem connected to the wall jack for
your Internet service.
If your modem uses a battery backup, remove the battery.
2. Plug in and turn on your modem.
If your modem uses a battery backup, put the battery back in.
3.
Connect your modem to the Internet port of your router with the Ethernet cable that
came with your router.
4. Connect the power adapter to your router and plug the power adapter into an outlet.
5.
Press the Power On/Off button on the rear panel of the router.
User Manual17Hardware Setup
Nighthawk X6 AC3000 Tri-Band WiFi Router
To Next Page
Loading...
