10
Add Adapters
To add adapters before you congure the network security feature,
just plug them in. On your computer, tablet, or smartphone,
connect with WiFi to the same PowerLINE WiFi network.
¾ To add an adapter to a PowerLINE network with
security set:
1. Plug the adapter into a wall outlet where you want to add
Internet access.
2. If you used a private encryption key, press the Security button
on one of the adapters that is already a part of the network for
two seconds, and then press the Security button on the new
adapter for two seconds.
Both buttons must be pressed within two minutes.
Note: The Security button does not work in power saving mode.
Warning: Do not press the Security button on the PowerLINE
adapter until installation is complete and the adapters are
communicating with each other (indicated by the blinking Power
LED). Pressing this button too soon can temporarily disable
PowerLINE communication. If this occurs, use the Factory Reset
button to return the PowerLINE adapter to its factory default
settings.
To Next Page
Loading...
Need help?
General
