9
Do More
After your PowerLINE network is installed and running, you can use
WPS to connect your access point, expand your network, customize
the network settings, and customize security.
Use WPS to Connect to Your Network
¾ To automatically connect to the PowerLINE access
point using a WPS button:
1. Press and hold the WPS button on the PowerLINE access point
for two seconds and release it.
The WiFi LED starts to blink.
2. Press the WPS button on your WiFi-enabled device for two
seconds and release it.
When the WiFi LED stops blinking, your WiFi device is
automatically connected to the PowerLINE access point and
you can surf the web.
To Next Page
Loading...
