NETGEAR RAX15

Front panel LEDs and buttons
The status LEDs and two buttons are located on the front of the router.
Figure 2. Top view
Table 1. LED descriptions
DescriptionLED and Button
•
Solid white. The router is ready.
•
Solid amber. The router is starting.
•
Blinking amber. The router is not ready, firmware is upgrading, or the Reset
button was pressed.
•
Off. Power is not supplied to the router.
Power LED
Pressing the WPS button lets your WPS-enabled device join your router's WiFi
network without typing the WiFi password. The WPS LED blinks white during
the WPS process and then lights solid white when the WPS-enabled device
connects to your router's WiFi network.
WPS LED
User Manual10Hardware Setup
4-Stream AX1800 WiFi 6 Router Model RAX15